"Dave Plowman (News)" wrote in message
...
In article op.uv2toucmhaghkf@lucy,
Duncan Wood wrote:
On Thu, 25 Jun 2009 11:29:04 +0100, Dave Plowman (News)
wrote:

I've been building a Tech Edge wideband lambda sensor convertor for use
with my Megatune - and the supplied connector for the sensor has
arrived
sans terminals. Obviously I can get them from Tech Edge - but they're
in
Oz and tend to take a while. It's a Bosch 7057 or 7200 Connector - pic
here.

http://wbo2.com/cable/connkit.htm

I suppose I wouldn't have too much trouble sourcing a complete plug
from
a
dealer - but wondered if anyone recognises the actual terminals as a
generic? I've checked out RS with no luck. They're female and accept a
thin blade 3.5mm wide.



There's a clue on
http://wbo2.com/cable/lsuconns.htm

"Terminals (with wires) # 000-979-133-A (also from AMP/Tyco)"

Ah - missed that bit. I'll try a search on that. Although of course I only
want the terminal - no wire.

The other obvious one would be to try the VW partnumber listed with the VW
dealer. They're normally quite good for that sort of bit, and reasonably
cheap.